Inspection Procedure 6

INSPECTION PROCEDURE 6: Noise while Turning [DIFFERENTIAL]

DIAGNOSIS

STEP 1. Check the side bearing for wear or damage.

Q:Is the side bearing worn or damaged?
YES : Replace the part. Then go to Step 3.
NO : Go to step 2.

STEP 2. Check the side gear, pinion gear or pinion shaft for damage.

Q:Is the side gear, pinion gear or pinion shaft damaged?
YES : Replace the part. Then go to Step 3.
NO : Go to Step 3.

STEP 3. Retest the system.

Q:Is the abnormal noise eliminated?
YES : The procedure is complete.
NO : Start over at Step 1.