Drive Belt: Testing and Inspection

DRIVE BELT TENSION CHECK

1. Remove the radiator condenser tank, and move the radiator condenser tank to a place where it does not interfere with the drive belt tension check.





2.
CAUTION:
Check the drive belt tension after turning the crankshaft clockwise one turn or more.

Make sure that the indicator mark on the auto-tensioner is within the area marked with A in the illustration.
3. If the mark is out of the area A, replace the drive belt (Refer to Service and Repair.)
NOTE:
The drive belt tension adjustment is not necessary as the auto-tensioner is adopted.

4. Install the radiator condenser tank to the original position.