P1706

DTC P1706: Malfunction of Throttle Signal

DIAGNOSTIC FUNCTION
TCM detects the abnormality in the throttle position signal sent from the ECM.

DESCRIPTIONS OF MONITOR METHODS
^ The difference between the throttle position signal received from the ECM and the corresponding turnover value is 1.37 V or more, and this status continues for 1 second.

MONITOR EXECUTION
^ Transmission range:D

MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
^ P0705: Malfunction of transmission range switch
^ P0715: Malfunction of primary pulley speed sensor
^ P0720: Malfunction of secondary pulley speed sensor
^ P0725: Malfunction of engine speed
^ P0741: Abnormality in lockup function
^ P0746: Abnormality in hydraulic control system function
^ P0841: Abnormality in line pressure sensor function

Sensor (The sensor below is determined to be normal)
^ Transmission range switch
^ Primary pulley speed sensor
^ Secondary pulley speed sensor

LOGIC FLOW CHARTS (Monitor Sequence)





DTC SET CONDITIONS

Check Conditions
^ Transmission range switch position: D.
^ Voltage of battery: 9 volts or more.
^ Voltage of battery: 16 volts or less.

Judgment Criteria
^ Throttle position toggle signal on CAN: fail. (1 second)

OBD-II DRIVE CYCLE PATTERN
Ignition switch : ON (start the engine and keep it for 10 seconds or more)

PROBABLE CAUSES
^ Malfunction of the CAN bus
^ Malfunction of engine system
^ Malfunction of TCM

DIAGNOSTIC PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnostics
Use M.U.T.-III to perform the CAN bus diagnosis.

Q:Is the check result normal?
YES : Go to Step 2.
NO : Repair the CAN bus lines (Refer to Troubleshooting, Diagnosis Code Chart). CAN Bus Diagnostics Chart

STEP 2. M.U.T.-III diagnosis code
Check if the engine-related diagnosis code is set.

Q:Is diagnosis code set?
YES : Diagnose the engine control system.
NO : Go to Step 3.

STEP 3. Symptom recheck after erasing diagnosis code

Q:Is the check result normal?
YES : Intermittent malfunction
NO : Replace TCM.