Inspection Procedure 10: Abnormality In Brake Operation
Inspection Procedure 10: Abnormality in brake operationCAUTION
^ If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines Refer to Trouble code diagnosis Diagnostic Trouble Code Descriptions.
^ Whenever ECU is replaced, ensure that the CAN bus lines are normal.
^ When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor, the G and yaw rate sensor and brake fluid pressure sensor.
COMMENTS ON TROUBLE SYMPTOM
Although the cause of the trouble cannot be clearly resolved since it depends on the running status and road surface condition, the malfunction of the hydraulic circuit may occur if any DTC is not detected.
PROBABLE CAUSES
^ Hydraulic unit (Integrated with ASC-ECU) malfunction
^ Malfunction of hydraulic circuit
^ Malfunction of brake assembly
^ Malfunction of brake booster
^ Malfunction of master cylinder assembly
DIAGNOSIS
Required Special Tools:
^ MB991958: Scan Tool (M.U.T.-III Sub Assembly)
^ MB991824: Vehicle Communication Interface (V.C.I.)
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A
STEP 1. DTC check
Use scan tool to check the DTC for the ASC system. (Refer to Diagnostic Trouble Code Descriptions)
Q: Is the check result normal?
YES: Go to Step 2.
NO: Troubleshoot for the relevant DTC (Refer to Diagnostic Trouble Code Descriptions).
STEP 2. Hydraulic unit (Integrated with ASC-ECU) check
Check that the brake tube is installed to the hydraulic unit (integrated with ASC-ECU) correctly.
Q: Is the check result normal?
YES: Go to Step 3.
NO: Connect the brake tubes correctly, repair the external brake lines, or replace the hydraulic unit (ASC-ECU).
STEP 3. Brake operation check
Perform the following checks.
^ Brake pedal check
^ Brake booster check
^ Check valve check
Q: Can any fault be found with the brake operation?
YES: Check the brake-related parts, and repair if necessary. Then, go to Step 4.
NO: Go to Step 4.
STEP 4. Hydraulic unit check
Perform the following actuator tests.
^ Item No.01: FL wheel ABS drive
^ Item No.02: FR wheel ABS drive
^ Item No.03: RL wheel ABS drive
^ Item No.04: RR wheel ABS drive
^ Item No.05: FL wheel TCL drive
^ Item No.06: FR wheel TCL drive
^ Item No.07: RL wheel TCL drive
^ Item No.08: RR wheel TCL drive
Q: Is the check result normal?
YES: The procedure is complete.
NO: Replace the hydraulic unit (ASC-ECU).