Rear Window Glass

REAR WINDOW GLASS

REMOVAL AND INSTALLATION

Pre-removal And Post-installation Operation:

Removal Steps 1-6:

REMOVAL SERVICE POINT

[[A]] REAR WINDOW GLASS REMOVAL

Remove the rear window glass using the same procedure as for the windshield.

NOTE: Use a piano wire to remove the rear window glass.

INSTALLATION SERVICE POINTS

]]A[[ FASTENER/REAR WINDOW SPACER/GLASS STOPPER/REAR WINDOW UPPER DAM/REAR WINDOW SIDE DAM INSTALLATION

CAUTION: Leave the degreased parts for 3 or more minutes to dry well, before starting on the next step. Do not touch the degreased parts.

1. Use 3M(TM) AAD Part number 8906 or equivalent. to degrease the inside and outside edges of the rear window glass and the surface of the body flange.







2. Install the fastener, rear window spacers, and glass stoppers to the specified positions so that there are no adrift or warped surfaces inside the rear window glass.







3. Install the fasteners to the specified positions on the body flange.







4. Install the rear window upper dam and side dam to the rear window glass.

]]B[[ REAR WINDOW GLASS INSTALLATION

1. Apply the primer and adhesive.
2. Install the rear window glass in the same way as for the windshield glass installation.