Inspection Procedure 14: Delay Occurs When The Lever Is Shifted From "N" to "D" or "N" to "R"

INSPECTION PROCEDURE 14: Delay occurs when the lever is shifted from "N" to "D" or "N" to "R".

COMMENTS ON TROUBLE SYMPTOM
Fluid may be insufficient or contaminated. TC-SST-ECU power supply circuit, mechatronic assembly, clutch assembly, or transaxle assembly may have a problem.

PROBABLE CAUSES
^ Malfunction of TC-SST-ECU power supply circuit
^ Insufficient or contaminated fluid
^ Malfunction of the mechatronic assembly
^ Malfunction of the clutch assembly
^ Malfunction of the transaxle assembly

DIAGNOSTIC PROCEDURE

STEP 1. Check the TC-SST-ECU power supply circuit
Inspection Procedure 4: TC-SST-ECU Power Supply Circuit Malfunction
Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the TC-SST-ECU power supply circuit.

STEP 2. Fluid check
Check for the fluid level and if no foreign material and contamination are found.
Q: Is the check result normal?
YES: Go to Step 3.
NO: Charge or replace the fluid.

STEP 3. Retest the system.
Q: Does a malfunction take place again?
YES: Replace the mechatronic assembly. Then go to Step 4.
NO: Intermittent malfunction.

STEP 4. Retest the system.
Q: Does a malfunction take place again?
YES: Replace the clutch assembly. Then go to Step 5.
NO: Intermittent malfunction.

STEP 5. Retest the system.
Q: Does a malfunction take place again?
YES: Replace the transaxle assembly.
NO: Intermittent malfunction.