P0745

DTC P0745: Malfunction of Line Pressure Solenoid Valve





DIAGNOSTIC FUNCTION
TCM determines malfunction by detecting the abnormality in the line pressure solenoid valve.

DESCRIPTIONS OF MONITOR METHODS
^ Specified amount of current is not flown to the line pressure solenoid valve because of an open or short circuit.

MONITOR EXECUTION
^ Continuous

MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
^ P0741: Abnormality in lockup function
^ P0746: Abnormality in hydraulic control system function
^ P0841: Abnormality in line pressure sensor function
^ P0868: Secondary pressure drop

Sensor (The sensor below is determined to be normal)
^ Not applicable

LOGIC FLOW CHARTS (Monitor Sequence)





DTC SET CONDITIONS

Judgment Criteria
^ Monitored current [target current: 750 mA or more]: 400 mA or less. (5 seconds)
^ Monitored current: 1.34 A or more. (1 second)

OBD-II DRIVE CYCLE PATTERN
Ignition switch: ON (start the engine and keep it for 10 seconds or more)

PROBABLE CAUSES
^ Malfunction of valve body assembly (Faulty line pressure solenoid valve)
^ Damaged wiring harness and connectors
^ Malfunction of TCM

DIAGNOSTIC PROCEDURE

STEP 1. M.U.T.-III data list
^ Item 33: Line pressure SOL. output current
^ Item 32: Line pressure SOL. monitor current
OK: Check if the output current and monitoring current differ largely.

Q: Is the check result normal?
YES: Intermittent malfunction
NO: Go to Step 2.

STEP 2. Check the following connector:
^ C-41 TCM connector
^ B-08 CVT assembly connector
Check the terminals for a contact status problem and internal short circuit.

Q: Is the check result normal?
YES: Go to Step 3.
NO: Repair the defective connector.

STEP 3. Check for open circuit and short to ground in the wiring harness between the TCM connector and the CVT assembly connector.
Between C-41 TCM connector (terminal No. 1) and B-08 CVT assembly connector (terminal No. 1)

Q: Is the check result normal?
YES: Go to Step 4.
NO: Repair the wiring harness.

STEP 4. Line pressure solenoid valve single unit check

Q: Is the check result normal?
YES: Go to Step 5.
NO: Replace the valve body assembly.

STEP 5. Symptom recheck after erasing diagnosis code

Q: Is the check result normal?
YES: Intermittent malfunction
NO: Replace TCM.