P0128

DTC P0128: Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature)

TECHNICAL DESCRIPTION
- The PCM checks the time for the cooling water temperature to reach the judgement temperature.

DESCRIPTIONS OF MONITOR METHODS
Engine coolant temperature does not reach 77 °C (171 °F) within specified period after cold start.

MONITOR EXECUTION
Once per driving cycle

DTC SET CONDITIONS

Logic Flow Chart:

MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
- Not applicable

Sensor (The sensor below is determined to be normal)
- Mass airflow sensor
- Engine coolant temperature sensor
- Intake air temperature sensor

Check Conditions
- Engine coolant temperature is between -10 °C (14 °F) and 60 °C (140 °F) when the engine is started.
- Intake air temperature is -10 °C (14 °F) or more.
- The intake air temperature when the engine is started - intake air temperature is 5 °C (9 °F) or less.
- The total time of the mass airflow sensor output whose state is over 10 g/sec within 600 seconds.

Judgement Criteria
- The time for the engine coolant temperature to rise to 77 °C (171 °F) takes longer than approximately 11 to 32 minutes.

OBD-II DRIVE CYCLE PATTERN
Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 10. OBD-II Drive Cycle

TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:)
- The thermostat is faulty.
- PCM failed.

DIAGNOSIS

STEP 1. Check the cooling system.
Refer to Symptom Chart. Symptom Chart

Q: Is the cooling system normal?

YES : Replace the PCM. When the PCM is replaced, register the encrypted code. Then go to Step 2.

NO : Repair it. Then go to Step 2.

STEP 2. Test the OBD-II drive cycle.

1. Carry out test drive with the drive cycle pattern. Refer to Diagnostic Function - OBD-II Drive Cycle - Pattern 10. OBD-II Drive Cycle
2. Check the diagnostic trouble code (DTC).

Q: Is DTC P0128 set?

YES : Retry the troubleshooting.

NO : The inspection is complete.