Inspection Procedure 3: ABS Warning Light Does Not Illuminate When Ignition Switch Is Turned to the ON Position

Inspection Procedure 3: ABS Warning Light does not Illuminate when Ignition Switch is Turned to the ON Position (Engine Stopped).

SYSTEM OPERATION
^ ABS-ECU sends the illumination request signal of the ABS warning light to the combination meter through ETACS-ECU via CAN communication.
^ ABS-ECU illuminates the ABS warning light via ETACS-ECU for approximately 3 seconds for valve check with the ignition switch turned to the ON position.

TECHNICAL DESCRIPTION (COMMENT)
This may be caused by faults in the CAN bus line, ETACS-ECU, combination meter or ABS-ECU.

PROBABLE CAUSES
^ Damaged wiring harness and connectors
^ Malfunction of ETACS-ECU
^ Combination meter malfunction
^ ABS-ECU malfunction
^ Malfunction of coding data for ETACS-ECU

DIAGNOSIS

Required Special Tools:
^ MB991958: Scan Tool (M.U.T-III Sub Assembly)
^ MB991824: Vehicle Communication Interface (V.C.I.)
^ MB991827: M.U.T.-III USB Cable
^ MB991910: M.U.T.-III Main Harness A

STEP 1. M.U.T.-III CAN bus diagnostics
Use scan tool to diagnose the CAN bus lines.
Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines.

STEP 2. M.U.T.-III actuator test
Perform the actuator test No.07 of the combination meter system, and check if the ABS warning light illuminates.
Q: Is the check result normal?
YES: Troubleshoot the combination meter, then go to Step 3.
NO: Go to Step 4.

STEP 3. Check coding data
Refer to Coding List.
Q: Is the check result normal?
YES: Go to Step 4.
NO: Replace ETACS-ECU.

STEP 4. M.U.T.-III other system diagnostic trouble code
Using scan tool, check that the diagnostic trouble code No. U0141 is not set by the combination meter system.
Q: Is the diagnostic trouble code set?
YES: Troubleshoot the combination meter, then go to Step 6.
NO: Go to Step 5.

STEP 5. M.U.T.-III other system diagnostic trouble code
Using scan tool, check that the diagnostic trouble code No. U0121 is not set by the ETACS system.
Q: Is the diagnostic trouble code set?
YES: Troubleshoot the ETACS-ECU, then go to Step 6.
NO: Replace the ABS-ECU, then go to Step 6.

STEP 6. Retest the system.
Q: Does the ABS warning light turn ON and OFF normally?
YES: The procedure is complete.
NO: Return to Step 1.