Inspection Procedure 24

INSPECTION PROCEDURE 24: No Sound. (CD Only)

DIAGNOSIS

STEP 1. Check again using another CD, which is not dirty or scratched.

Q: When you substitute another normal CD, is the CD played normally?

YES : The original CD is defective. The CD player should sound normally.

NO : Go to Step 2.

STEP 2. Check power supply to the CD player when the ignition switch is at "ACC" or "ON" position.

Q: Is the radio and CD player energized when the ignition switch is turned to the "ACC" or "ON" position?

YES : Replace the audio. The CD player should sound normally.

NO : Check the memory backup power supply circuit. Refer to Inspection Procedure 1. Inspection Procedure 1