Wireless Control Module (WCM)
DTC B1A24: Key ID not registeredDTC SET CONDITION
WCM sets DTC B1A24 when the key ID was not registered in it.
TECHNICAL DESCRIPTION (COMMENT)
WCM determines that the abnormality is present, if the ignition key's key ID is not registered in WCM when the ignition switch is turned ON.
TROUBLESHOOTING HINTS
- Key ID not registered
- Malfunction of the ignition key
- Malfunction of WCM
DIAGNOSIS
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: M.U.T.-III USB Cable
- MB991910: M.U.T.-III Main Harness A
STEP 1. Using scan tool MB991958, diagnose the CAN bus line.
CAUTION: To prevent damage to scan tool (MB991958), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (MB991958).
1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. Diagnose the CAN bus line.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the CAN bus line found to be normal?
YES : Go to Step 2.
NO : Repair the CAN bus line (Refer to Controller area network Diagnosis).
STEP 2. Register the key ID and recheck the diagnostic trouble code.
Register the key ID of the ignition key, and recheck if the DTC is set.
1. Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
2. Check if the DTC is set.
Q: Is the DTC set?
YES : Go to Step 3.
NO : The procedure is complete.
STEP 3. Replace the ignition key and recheck the diagnostic trouble code.
Replace the ignition key with the other key, and recheck if the DTC is set.
1. Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
2. Check if the DTC is set.
Q: Is the DTC set?
YES : Go to Step 4.
NO : The procedure is complete.
STEP 4. Register the key ID and recheck the diagnostic trouble code.
Register the key ID of the ignition key, and recheck if the DTC is set.
1. Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
2. Check if the DTC is set.
Q: Is the DTC set?
YES : Go to Step 5.
NO : The procedure is complete.
STEP 5. Replace the ignition key and recheck the diagnostic trouble code.
Replace the ignition key with a new one, register the key ID and keyless ID (if so equipped) of the new key, and recheck if the DTC is set.
1. Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
2. Check if the DTC is set.
Q: Is the DTC set?
YES : Replace WCM and register the ID codes.
NO : The procedure is complete.