P1827

DTC P1827: Shift Fork Position Sensor 2 System (Output range out)

CAUTION:
^ If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
^ Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

DIAGNOSTIC FUNCTION
TC-SST-ECU checks that the output of the shift fork position sensor 2 is normal.

DESCRIPTIONS OF MONITOR METHODS
The output of the shift fork position sensor 2 is determined to be abnormal.

MONITOR EXECUTION
^ Continuous

MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
^ P1825: Shift fork position sensor 2 system (Voltage low range out)
^ P1826: Shift fork position sensor 2 system (Voltage high range out)
^ P1828: Shift fork position sensor 2 system (Neutral)
^ P1829: Shift fork position sensor 2 system (Poor performance)
^ P183D: Shift fork 2 malfunction
^ P1852: Shift fork 1 or 2 opposite direction movement
^ P1855: Shift fork 3 or 4 opposite direction movement
^ P1857: Odd number gear axle interlock
^ P1876: Gear block 1st
^ P1877: Gear block 2nd
^ P1878: Gear block 3rd
^ P1879: Gear block 4th
^ P187A: Gear block 5th
^ P18713: Gear block 6th
^ P187C: Gear block reverse

Sensor (The sensor below is determined to be normal)
^ Not applicable

LOGIC FLOW CHARTS (Monitor Sequence)





DTC SET CONDITIONS

Check Conditions
^ Voltage of battery: 8 V or more.
^ Voltage of battery: 16.5 V or less.
^ Engine speed: 500 r/min or more.
^ Time since above engine condition: 400 millisecond or more.
^ Shift system status: Gear change mode (during shift fork moving).

JUDGMENT CRITERIA
Shift fork 2 position counter (digitized sensor value):-500 counts or less, or shift fork 2 position counter (digitized sensor value): 500 counts or more. (180 millisecond)

OBD-II DRIVE CYCLE PATTERN
The status with the shift fork 2 position counter (digitized sensor value)-500 counts or more, or with the shift fork 2 position counter (digitized sensor value) 500 counts or less continues for 180 milliseconds.

PROBABLE CAUSES
^ Malfunction of TC-SST-ECU

DIAGNOSTIC PROCEDURE

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.

Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines. After repairing the CAN bus line, go to Step 2.

STEP 2. Check whether the DTC is reset.

Q: Is DTC No. P1827 set?
YES: Replace the TC-SST assembly.
NO: Intermittent malfunction.