P0841

DTC P0841: Clutch 1 Pressure Sensor System (Poor performance)

CAUTION:
^ If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines.
^ Whenever the ECU is replaced, ensure that the CAN bus lines are normal.

DIAGNOSTIC FUNCTION
TC-SST-ECU checks that the clutch 1 pressure sensor is normal.

DESCRIPTIONS OF MONITOR METHODS
The difference between the allowable torque of clutch 1 and the engine torque is large.

MONITOR EXECUTION
^ Continuous

MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)

Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
^ P0842: Clutch 1 pressure sensor system (Output low range out)
^ P0843: Clutch 1 pressure sensor system (Output high range out)
^ P0753: Shift select solenoid 1 system (Open circuit)
^ P0973: Shift select solenoid 1 system (Short to ground)
^ P0974: Shift select solenoid 1 system (Short to power supply)
^ P2733: Clutch/shift switching solenoid 1, spool stuck
^ P2736: Clutch/shift switching solenoid 1 system (Open circuit)
^ P2738: Clutch/shift switching solenoid 1 system (Short to ground)
^ P2739: Clutch/shift switching solenoid 1 system (Short to power supply)
^ P181 B: Clutch 1 (Pressure low range out)
^ P181C: Clutch 1 (Pressure high range out)
^ P1859: Disengagement too late with clutch 1
^ P181 E: Clutch 2 (Pressure low range out)
^ P181 F: Clutch 2 (Pressure high range out)
^ P185B: Disengagement too late with clutch 2
^ P185D: Clutch open not possible

Sensor (The sensor below is determined to be normal)
^ Shift select solenoid 1
^ Clutch/shift switching solenoid 1

LOGIC FLOW CHARTS (Monitor Sequence)





DTC SET CONDITIONS

Check Conditions
^ Voltage of battery: 8 V or more.
^ Voltage of battery: 16.5 V or less.
^ Engine speed: 500 r/min or more.
^ Time since above engine condition: 400 millisecond or more.
^ Engine speed: 6,800 r/min or less.
^ Clutch 1 (odd) slip state: Slip or engaged.
^ Clutch 1 (odd) slip speed: 20 r/min or more.
^ Clutch 2 (even) state: Disengaged.

JUDGMENT CRITERIA
^ Calculated torque (Clutch 1 (odd) permit torque engine torque): 200 Nm (148 ft-lb) or more. (2 seconds)

OBD-II DRIVE CYCLE PATTERN
The value of the calculated torque (clutch 1 (odd) permit torque engine torque) remains 200 Nm (148 ft-lb) or less for 2 seconds.

PROBABLE CAUSES
^ Malfunction of TC-SST-ECU

DIAGNOSTIC PROCEDURE

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.

Q: Is the check result normal?
YES: Go to Step 2.
NO: Repair the CAN bus lines. After repairing the CAN bus line, go to Step 2.

STEP 2. Check whether the DTC is reset.

Q: Is DTC No. P0841 set?
YES: Replace the TC-SST assembly.
NO: Intermittent malfunction.