Inspection Procedure 22

No sound. (CD only)

DIAGNOSIS

STEP 1. Check again using a normal CD, which is not dirty or scratched.

Q: When you substitute another normal CD, is the CD played normally?

YES: The original CD is defective. The CD player should sound normally.

NO: Go to Step 2.

STEP 2. Check power supply to the CD player when the ignition switch is at "ACC" or "ACC".

Q: Is the radio and CD player energized when the ignition switch is turned to the "ACC" or "ON position?

YES: Replace the CD player. The CD player should sound normally.

NO: Check the memory backup power supply circuit. Refer to Inspection Procedure 1.