Inspection Procedure 19

Using the Auto Select Function, Too Few Automatic Stations are Selected.

DIAGNOSIS

STEP 1. Check the state of the antenna.

Q: Is the roof antenna pole assembled?

YES: Go to Step 2.

NO: Assemble the roof antenna pole. The auto-select function should operate normally.

STEP 2. Check the number of radio stations.

Q: Are there sufficient numbers of radio stations within the area?

YES: Go to Step 3.

NO: Go to Step 4.

STEP 3. Check the distance from the transmission antenna.

Q: Is there a transmission antenna within miles?

YES: Go to Step 5.

NO: Go to Step 4.

STEP 4. Check if there are not that many radio stations and when there is no transmission antenna in the vicinity.
Execute automatic selection and check to see that the strongest radio frequency is receivable within the area.

Q: Is reception of the strongest radio frequency possible within the area?

YES: There is no action to be taken.

NO: Go to Step 5.

STEP 5. Check to see if the inspection are taking place is an area exposed to special electric fields.

Q: Is inspection taking place under special electric field conditions? (underground garage, inside a building, etc.)?

YES: Go to Step 6.

NO: Go to Step 7.

STEP 6. Move the vehicle and recheck.
Move the vehicle to in a good reception area that is not exposed to special electric fields.

Q: Is reception of the strongest radio frequency possible within the area?

YES: There is no action to be taken.

NO: Go to Step 7.

STEP 7. Check the connection of the antenna plug and radio and CD player.

Q: Is the antenna plug properly connected to the radio and CD player?

YES: Replace the radio and CD player. The auto-select function should operate normally.

NO: Securely connect the antenna plug and the radio and CD player. The auto-select function should operate normally.