Inspection Procedure 23

INSPECTION PROCEDURE 23: CD can not be Inserted

DIAGNOSIS

STEP 1 Check that a CD has been already loaded

Q: Has a CD been already loaded?

YES: Take out the CD (If the CD can not be ejected, refer to INSPECTION PROCEDURE 27 Check that a CD can be inserted

NO: Go to Step 2

STEP 2 Check how a CD is inserted

Ensure that the ignition switch is at 'ACC' or 'ON'

NOTE: If you try to load a CD when the ignition switch is at the positions other than 'ACC' or 'ON,' the CD will not be inserted completely and then rejected

Q: If you try to load the CD, does the CD stops halfway and then rejected?

YES: Refer to INSPECTION PROCEDURE 27

NO: Go to Step 3

STEP 3 Check after the CD is loaded

NOTE: Even though the CD is loaded, 'E01' [vehicles with multi-center display (low grade type)] or 'ERROR 01' [vehicles with multi-center display (middle grade type)] sometimes displayed with the CD rejected because of vibration/shock or dew on the CD face or optical lens

Q: Though the CD is inserted completely, is 'E01' [vehicles with multi-center display (low grade type)] or 'ERROR 01' [vehicles with multi-center display (middle grade type)] displayed and the CD ejected?

YES: Go to Step 4

NO: There is no action to be taken

STEP 4 Check the CD

Check the CD for the conditions :
- Is the CD loaded with its label facing down?
- Is the recorded face dirty or scratched?
- Is there dew on the recorded face?

Q: Is the CD in good condition?

YES: Go to Step 5

NO: The original CD is defective Check that a CD can be inserted

STEP 5 Check again using a normal CD, which is not dirty or scratched

- Load another normal CD
- Check that the CD player recognizes and play the CD

Q: When you substitute another normal CD, is the CD loaded correctly?

YES: The original CD is defective Check that a CD can be inserted

NO: Replace or repair the CD player Check that a CD can be inserted