Inspection Procedure 5

INSPECTION PROCEDURE 5: Selector Lever cannot be Moved from R to P Position.

TECHNICAL DESCRIPTION (COMMENT)
Selector lever assembly, transaxle control cable, or lock cam may be defective.

TROUBLESHOOTING HINTS
^ Malfunction of selector lever assembly
^ Malfunction of transaxle control cable
^ Malfunction of lock cam

DIAGNOSIS
STEP 1. Check the connection of selector lever assembly and transaxle control cable.
Q: Is the connection of selector lever assembly and transaxle control cable in good condition?
YES: Go to Step 2.
NO: Repair the connection of selector lever assembly and transaxle control cable. Check that the selector lever can be moved from R position to P position.

STEP 2. Check the fit of the lock cam.
Q: Is the lock cam installed correctly?
YES: Go to STEP 3.
NO: Install the lock cam correctly. Check that the selector lever can be moved from R position to P position.

STEP 3. Check the lock cam.
Q: Is the lock cam in good condition?
YES: Go to Step 4.
NO: Replace the selector lever assembly. Check that the selector lever can be moved from R position to P position.

STEP 4. Check the fit of the transaxle control cable.
Q: Is the transaxle control cable installed correctly?
YES: Go to Step 5.
NO: Install the transaxle control cable correctly. Check that the selector lever can be moved from R position to P position.

STEP 5. Check the transaxle control cable.
Q: Is the transaxle control cable in good condition?
YES: Repair or replace the selector lever assembly. Check that the selector lever can be moved from R position to P position smoothly.
NO: Replace the transaxle control cable. Check that the selector lever can be moved from R position to P position.