DTC 95

DTC 95: Side Impact Sensor (RH) System for Fault 1

DTC SET CONDITIONS
These DTC are set if the followings are detected from the analog G-sensor inside the side impact sensor output.
- Analog G-sensor is not operating.
- Analog G-sensor characteristics are abnormal.
- Analog G-sensor output is abnormal.

TROUBLESHOOTING HINTS
Malfunction of side impact sensor (LH) (for DTC 92) and side impact sensor (RH) (for DTC 95)

DIAGNOSIS

Required Special Tools:
- MB991958: Scan Tool (MUT-III Sub Assembly)
- MB991824: Vehicle Communication Interface (V.C.I.)
- MB991827: MUT-III USB Cable
- MB991911: MUT-III Main Harness B (Vehicles without CAN communication system)

Replace side impact sensor (LH) (for DTC 92) and side impact sensor (RH) (for DTC 95). Check the diagnostic trouble code.

Q: Is any of DTC 92 or 95 set?

YES: Replace the SRS-ECU.

NO: The procedure is complete.