Inspection Procedure 5

Blower Fan And Motor Does Not Stop Turning.




STEP 1. Check the wiring harness between the blower fan and motor connector C-17 (terminal 1), the resistor connector C-16 (terminals 1, 2, 3 and 4) and the blower switch connector C-48 (terminals 1, 4, 5 and 6).

Q: Is the wiring harness between the blower fan and motor connector C-17 (terminal 1), the resistor connector C-16 (terminal 1, 2, 3 and 4), and the blower switch connector C-48 (terminals 1, 4, 5 and 6) in good condition?

YES: Go to Step 2.

NO: Repair the wiring harness. Then go to Step 4.

STEP 2. Check the blower relay continuity.







Follow the table to check the blower relay for continuity.

Q: Is the blower relay continuity in good condition?

YES: Go to Step 3.

NO: Replace. Then go to Step 4.

STEP 3. Check the blower switch continuity.







Follow the table to check the blower switch for continuity.

Q: Is the blower switch continuity in good condition?

YES: Go to Step 4.

NO: Replace. Then go to Step 4.

STEP 4. Check symptoms.

Q: Does the blower motor stop turning?

YES: This diagnosis is complete. (If no malfunctions are not found in all steps, an intermittent malfunction is suspected. Refer to How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction.)

NO: Go to Step 1.