Inspection Procedure 2
INSPECTION PROCEDURE 2: Engine OverheatingDIAGNOSIS
STEP 1. Remove the radiator cap and check for coolant contamination.
Q: Is the coolant contaminated with rust and oil?
YES: Replace it.
NO: There is no action to be taken, go to Step 2.
STEP 2.Check the radiator cap valve opening pressure.
NOTE: Be sure that the cap is clean before testing. Rust or other foreign material on the cap seal will cause an improper reading.
1. Use a cap adapter to attach the cap to the tester.
2. Increase the pressure until the gauge indicator stop moving.
Minimum limit: 64 kPa (9.2 psi)
Standard value: 73 - 103 kPa (11 - 15 psi)
Q: Does the reading remain at or above the minimum limit?
YES: Go to Step 3
NO: Replace the radiator cap. Then go to Step 5.
STEP 3. Check thermostat operation.
Q: Is the thermostat operate correctly?
YES: Go to Step 4
NO: Replace the thermostat, then go to Step 5.
STEP 4. Check the drive belt for slippage or damage.
Q: Is the drive belt loose or damaged?
YES: Adjust or replace the drive belt, then go to Step 5.
NO: There is no action to be taken
STEP 5. Check symptoms.
Check the coolant temperature gauge.
Q: Is the coolant temperature abnormally high?
YES: Return to Step 2
NO: This diagnosis is complete.