Inspection Procedure 3
INSPECTION PROCEDURE 3: Clutch NoiseDIAGNOSIS
STEP 1. Check insufficient clutch pedal play.
Q: Does the clutch pedal play meet the standard value?
YES: Go to Step 2
NO: Adjust the clutch pedal play Then go to Step 7.
STEP 2. Check the clutch release bearing for wear.
Q: Is the clutch release bearing worn?
YES: Replace the clutch release bearing. Then go to Step 7.
NO: Go to Step 3.
STEP 3. Check the bearing sleeve sliding surface for insufficient.
Q: Is the lubrication of the bearing sleeve sliding surface sufficient?
YES: Go to Step 4
NO: Repair the bearing sleeve sliding surface Then go to Step 7.
STEP 4. Check the clutch cover assembly for improper installation.
Q: Is the clutch cover assembly installed properly?
YES: Go to Step 5
NO: Install the clutch cover assembly properly. Then go to Step 7
STEP 5. Check the clutch disc facing for excessive wear.
Q: Is the clutch disc facing assembly worn excessively?
YES: Replace the clutch disc. Then go to Step 7
NO: Go to Step 6.
STEP 6. Check the pilot bushing for damage.
Q: Is the pilot bushing damaged?
YES: Replace the pilot bushing. Then go to Step 7
NO: Go to Step 7
STEP 7. Check the symptom.
Q: Is the symptom reproduced?
YES: Return to Step 1.
NO: This diagnosis is complete