Inspection Procedure 5

The Outside Temperature and Compass Screen Do Not Change

Vehicle Speed Sensor Circuit:

Connectors:

CIRCUIT OPERATION
Vehicle speed sensor signal is sent to multi-center display.

TECHNICAL DESCRIPTION (COMMENT)
Outside temperature and compass display on multi-center display won't be updated until vehicle speed gets 6.2 mph (10 km/h) or more.

TROUBLESHOOTING HINTS
- Malfunction of the vehicles speed sensor.
- Malfunction of the multi-center display.
- Damaged harness wires and connectors

DIAGNOSIS

STEP 1. Check the speedometer

Q: Is the speedometer in good condition?

YES: Go to Step 2.

NO: Refer to Combination Meter - Troubleshooting under Instrument Panel/Testing.










STEP 2. Check the connector between vehicles speed sensor connector B-39 and multi-center display connector C-09 for damage.

Q: Are the vehicles speed sensor connector B-39 and multi-center display connector C-09 in good condition?

YES: Go to Step 3.

NO: Repair or replace it. Refer to Harness Connector Inspection.













STEP 3. Check the harness wires between vehicles speed sensor connector B-39 and multi-center display connector C-09.

NOTE: After checking intermediate connector B-36 and C-28, joint connector C-77, check the wires. If intermediate connector B-36 and C-28, joint connector C-77 are damaged, repair or replace them. Refer to Harness Connector Inspection.

Q: Is the harness wires between vehicles speed sensor connector E-39 and multi-center display connector C-09 in good condition?

YES: Replace the multi-center display.

NO: Repair or replace it. Refer to Harness Connector Inspection.