Test 4 - No Communication Between Scan Tool and SRS-ECU

TEST 4 - NO COMMUNICATION BETWEEN SCAN TOOL AND SRS-ECU
(SRS warning light does not extinguish)





NOTE:
*1: To 1994 models
*2: From 1995 models

Wiring Diagram





SRS-ECU Connector





Check Harness Hook-Up





Flow Chart

PROCEDURES





(1) Turn the ignition key to the "LOCK' position, disconnect the negative battery cable and tape the terminal.

CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

(2) Remove the floor console assembly.
(3) Remove the SRS-ECU connector lock by the following procedure.





If there is no notch in the connector lock lever (Type 1)

1) Place a flat tip screwdriver against the lock spring (metal section) of the connector lock lever as shown in the illustration, and push the spring horizontally toward the inside of the unit.

CAUTION:
1. Do not use excessive force to raise the lock lever.
2. Do not insert the screwdriver into the gap between the lock lever and the lock spring.





If there is a notch in the connector lock lever (Type 2)

(1) Place a flat tip screwdriver against the lock spring (metal section) at the lock lever notch as shown in the illustration, and~push the spring toward the unit.

CAUTION: Do not use excessive force to raise the lock lever.

(4) Disconnect the red 14-pin connector from the SRS-ECU
(5) Connect the now disconnected red harness-side SRS-ECU connector (14-pin) to the connector 3. of the SRS Check Harness.
(6) Check according to the flow chart, using the specified digital multi-meter.