Intake Manifold: Service and Repair

11 61 050 - Removing and installing intake air manifold (N14)





Necessary preliminary tasks:
- Disconnect battery negative Service and Repair lead.
- Remove suction filter housing.





Note:
Picture shows EPPC removed.

Disconnect vacuum lines on vacuum connection (1 and 2).

Disconnect plug connection at EPPC.

Installation:
OUT connector (1) is identified with a green ring.





Disconnect plug connection (1) on tank vent valve (2).
Detach hose from tank vent valve (2).





Unscrew nuts (1).
Tightening torque: 11 61 1AZ [1][2]11 61 Intake Manifold.





Installation:
OUT connector on EPPC is identified with a green ring.
Vacuum line (1) is fitted with a green ring (OUT).
Vacuum line (2) without green ring (VAC).





Installation:
Replace all seals.

Assemble engine.