51 24 070 Removing and Installing/Replacing Retractor

51 24 070 - Removing and installing/replacing retractor





Necessary preliminary tasks:
- Remove panel for rear lid .
- Partially remove emergency release device 51 24 095 Removing and Installing/Replacing Emergency Release Device for Rear Lid.





Release screw (1) on retractor Bowden cable (2) and feed out in direction of arrow.

Installation:
Tightening torque 51 24 4AZ [1][2]Specifications.

Important!
When removing retractor Bowden cable (2), protect bumper against damage.





Warning!
Retractor Bowden cable is tensioned (risk of injury).





Release screws (1) on Bowden cable holder (2).

Installation:
Tightening torque 51 24 5AZ [1][2]Specifications.





Release nuts (1) on retractor (2) and remove retractor (2) towards top.

Installation:
Tightening torque 51 24 6AZ [1][2]Specifications.