Motor Electronics Pump

Motor Electronics Pump









1. Drain the Motor Electronics Cooling System (MECS). For additional information, refer to Motor Electronics Cooling System Draining and Filling Motor Electronics Cooling System Draining and Filling.

2. Disconnect the MECS cooling pump electrical connector.





3. Compress the 2 retainers, remove the MECS pump from the bracket and pull the MECS pump down to gain access to the constant tension clamps that hold the hoses on.





4. Compress the constant tension clamps and disconnect the inlet and outlet hoses from the MECS pump.





5. To install, reverse the removal procedure.