Removal and Replacement

Engine Mount













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the engine coolant degas bottle. For additional information, refer to Engine Cooling - Hybrid Service and Repair.

3. Install the Engine Support Bar to the front and rear engine lifting eyes.





4. Remove the engine mount bracket bolt.
- To install, tighten to 115 Nm (85 lb-ft).

5. Use the Engine Support Bar to raise the engine 25 mm (0.98 in).





6. Remove the bolt and the ground strap from the engine mount bracket.
- Tighten to 10 Nm (89 lb-in).

7. Remove the 3 nuts and the engine mount bracket.
- To install, tighten to 103 Nm (76 lb-ft).

8. Remove the 2 bolts and nut and the engine mount.
- To install, tighten to 55 Nm (41 lb-ft).

9. To install, reverse the removal procedure.