Fan Shroud: Service and Repair

Cooling Fan Motor and Shroud

Cooling Fan and Shroud (View 1 of 2)









Cooling Fan and Shroud (View 2 of 2)









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. If equipped, detach the 2 block heater wiring retainers from the cooling fan motor and shroud.

3. Remove the splash shield.





4. Detach the lower radiator hose pin-type retainer from the cooling fan motor and shroud.

5. Remove the battery tray. For additional information, refer to Battery, Mounting and Cables Battery Tray.

6. Remove the 2 bolts and position the auxiliary relay box aside.
- To install, tighten to 8 Nm (71 lb-in).

7. Detach all the wiring harness retainers from the cooling fan and shroud.

8. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.

9. Disconnect the cooling fan electrical connector.

10. NOTE: LH shown, RH similar.

Release the 2 tabs and remove the cooling fan motor and shroud.





11. To install, reverse the removal procedure.