Front Display Interface Module (FDIM)

Front Display Interface Module (FDIM) - Fusion, Milan

NOTE: Without navigation shown, with navigation similar.











Removal and Installation

NOTE: Vehicles without navigation require Programmable Module Installation (PMI) when a new module is being installed. For vehicles without navigation, the Front Display Interface Module (FDIM) is not a stand-alone module.

1. For vehicles without navigation, upload the FDIM configuration information to the scan tool. For additional information, refer to PMI in Module Configuration Programmable Module Installation (PMI).

2. Remove the instrument panel center finish panel. For additional information, refer to Instrument Panel and Console Instrument Panel Finish Panel - Center.

3. NOTICE: For vehicles with navigation, make sure not to bend the video cable when removing the FDIM.

Remove the 4 screws and the FDIM.

- Disconnect the electrical connectors.

4. To install, reverse the removal procedure.
- For vehicles without navigation, download the configuration information to the FDIM. For additional information, refer to PMI in Module Configuration Programmable Module Installation (PMI).