Blind Spot Module: Service and Repair

Side Obstacle Detection (SOD) Module

NOTE: Rear bumper cover removed for clarity.

NOTE: Left rear quarter panel shown, right side similar.











Bracket









Removal and Installation

Side obstacle detection (SOD) module only

1. NOTE: Module configuration is only required if a new Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) is being installed. Upload the SOD-L or SOD-R module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI)

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the 3 rear fender splash shield push pins. For additional information, refer to Front End Body Panels - Exploded View in Bumpers Bumper - Exploded View, Front.

3. Remove the 4 lower rear bumper quarter panel splash shield screws.

4. Remove the rear bumper cover screw and gently flex it to access the SOD-L or the SOD-R.
- Remove the screw and washer.

- Disconnect the electrical connector.

5. Remove the SOD-L or the SOD-R.

6. To install, reverse the removal procedure.
- Download the SOD-L or the SOD-R configuration information. For additional information, refer to Module Configuration [1][2]Initial Inspection and Diagnostic Overview.

- NOTE: When enabling the Blind Spot Information System (BLIS(R)) and Cross Traffic Alert (CTA) system make sure to enable the systems in both the SOD-L and the SOD-R. Failure to do so results in a mismatch system fault.

Verify in the programmable parameters that the Blind Spot Information System (BLIS(R)) and Cross Traffic Alert (CTA) system are enabled in the SOD-L and SOD-R.

- After the SOD-L or the SOD-R is configured, shift the selector lever though all the transaxle gear positions (PRNDL).

SOD-L/SOD-R Bracket only

7. Remove the rear bumper cover. For additional information, refer to Bumpers Service and Repair.

8. Remove the SOD-L or the SOD-R.
- Remove the screw and washer.

- Disconnect the electrical connector and the wiring harness retainer.

9. NOTE: The SOD-L/SOD-R bracket has a strip of adhesive tape that holding it to the vehicle.

Using a suitable tool, such as a flat-bladed scraper, pry the SOD-L/SOD-R bracket away from the vehicle.

- To install, apply hand pressure over the adhesive tape bonding area for a minimum of 15 seconds.





10. NOTE: Remove the adhesive tape protective cover before installing the retaining tabs in the vehicle body.

NOTE: When installing the new SOD-L/SOD-R bracket, make sure the retaining tab portion of the SOD-L/SOD-R bracket snaps firmly into the vehicle and 2 audible clicks are heard.

Using a suitable tool, such as pliers, squeeze the retaining tabs of the SOD-L/SOD-R bracket, located in the luggage compartment behind the side carpet panel, and remove the SOD-L/SOD-R bracket.

- Discard the SOD-L/ SOD-R bracket.





11. NOTE: Allow the adhesive tape bonding surface to completely dry before installing the new SOD-L/SOD-R bracket.

Clean the adhesive tape bonding surface.

- Using a flat bladed wood or plastic scraper remove the remaining adhesive from the vehicle body.

- Clean the adhesive tape bonding surface on the vehicle body with isopropyl alcohol (obtain locally).

12. To install, reverse the removal procedure.