Compass Zone Adjustment

Compass Zone Adjustment

NOTE: This procedure is only applicable to vehicles without navigation.

1. Refer to the compass calibration zone map to select the correct compass zone setting for the geographic location of the vehicle.





2. With the ignition in the ON position, press and hold the Front Controls Interface Module (FCIM) (Fusion/Milan) or Front Display Interface Module (FDIM) (MKZ) 7 and 9 buttons (for approximately 5 seconds) until the compass display shows the current zone setting (ZONE XX). Release the 7 and 9 buttons.

3. NOTE: After the 7 and 9 buttons have been released for approximately 5 seconds, the compass display exits the zone setting mode.

Before the zone setting mode turns off (within 5 seconds), momentarily press and release the 7 and 9 buttons to increase the zone increment by one. Set the zone display number to match the vehicle geographical location on the compass calibration zone map.

4. Release the 7 and 9 buttons for 5 seconds to exit the zone setting mode.