Oil Pump Screen and Pickup Tube

Oil Pump Screen and Pickup Tube





Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan, may cause engine failure.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the oil pan. For additional information, refer to Engine Lubrication Components - Exploded View Engine Lubrication Components - Exploded View and Oil Pan Oil Pan.

3. Remove the bolts the oil pump screen and pickup tube.
- Remove and discard the O-ring seal.





Installation

1. Install a new O-ring seal on the oil pump screen and pickup tube.
- Lubricate the O-ring seal with clean engine oil.

2. Install the oil pump screen and pickup tube.

1. Position the oil pump screen and pickup tube.

2. Install the bolts and tighten to 10 Nm (89 lb-in).





3. Install the oil pan. For additional information, refer to Oil Pan Oil Pan.