Oil Level Indicator and Tube

Oil Level Indicator and Tube













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the oil level indicator.

3. If equipped, disconnect the block heater electrical connector and wiring harness retainers.

4. Remove the stud bolt and the oil level indicator tube.
- Discard the O-ring seal.

- To install, tighten to 9 Nm (80 lb-in).

5. NOTE: Install a new O-ring seal and lubricate with clean engine oil.

To install, reverse the removal procedure.