Fan Shroud: Service and Repair

Cooling Fan Motor and Shroud - 2.5L, 3.0L (4V)

2.5L and 3.0L Engines









1. Detach all the wiring harness retainers from the cooling fan and shroud.

2. If equipped, detach the 2 block heater wiring retainers from the cooling fan motor and shroud.

3. Remove the splash shield.





4. Detach the RH lower radiator hose pin-type retainer from the cooling fan motor and shroud.

5. If equipped, detach the 2 transmission cooler tube retainers from the cooling fan motor and shroud.

6. If equipped, detach the LH lower radiator hose pin-type retainer from the cooling fan motor and shroud.

7. Disconnect the cooling fan electrical connector.
- Detach the pin-type retainer.

8. NOTE: LH shown, RH similar.

Release the 2 tabs and remove the cooling fan motor and shroud.





9. To install, reverse the removal procedure.