Universal Serial Bus (USB) Cable and Port

Universal Serial Bus (USB) Cable and Port

NOTE: Fusion, Milan shown, MKZ similar.











Removal and Installation

1. Remove the floor console. For additional information, refer to Instrument Panel and Console Service and Repair.

2. Disconnect the Universal Serial Bus (USB) cable and port-to-bezel connector.

3. Remove the floor console rear trim panel by pulling straight back to disengage the clips.

4. NOTICE: Be careful not to flex the floor console RH side panel too much, or damage to the floor console may occur.

Remove the USB cable and port.

- Disconnect the USB cable and port-to-Accessory Protocol Interface Module (APIM) electrical connector.

- Carefully flex the floor console RH side panel and remove the USB cable and port.

5. To install, reverse the removal procedure.