Pinpoint Test A: DTC B10D5:13

Anti-Theft

Pinpoint Test A: DTC B10D5:13

Normal Operation
- DTC B10D5:13 ( PATS Antenna: Circuit Open ) - a continuous and on-demand DTC that sets when there has been a Passive Anti-Theft System (PATS) transceiver antenna failure. The PATS transceiver may need to be replaced.

This pinpoint test is intended to diagnose the following:

- PATS transceiver


PINPOINT TEST A: DTC B10D5:13

-------------------------------------------------
A1 INSPECT THE PATS TRANSCEIVER FOR CORRECT INSTALLATION

NOTE: Replacement of the PATS transceiver does not require the PATS keys to be programmed into the Instrument Panel Cluster (IPC) again.

- Ignition OFF.
- Verify the PATS transceiver is correctly installed. Refer to Passive Anti-Theft System (PATS) Transceiver Service and Repair.
- Ignition ON.
- Clear the IPC DTCs.
- Ignition OFF.
- Ignition ON.
- Retrieve the IPC DTCs.
- Is DTC B10D5:13 retrieved?

Yes
INSTALL a new PATS transceiver. REFER to Passive Anti-Theft System (PATS) Transceiver Service and Repair. CLEAR the DTCs. CYCLE the ignition. REPEAT the self-test.

No
The system is OK.

-------------------------------------------------