Air Dryer: Service and Repair

Air Suspension Compressor Drier













Removal and Installation

1. Remove the air suspension compressor. For additional information, refer to Air Suspension Compressor Service and Repair.

2. Remove the air suspension compressor drier.

1. Remove the screw.
- To install, tighten to 3 Nm (27 lb-in).

2. Rotate the air compressor drier 90 degrees to unlock, then remove the air suspension compressor drier.





3. NOTE: Inspect the O-ring for damage and install a new O-ring as necessary. Lubricate the solenoid seal area with grease.

NOTE: When installing the air tubes, make sure the white tube is fully inserted into the fitting for correct installation.

To install, reverse the removal procedure.