Front Suspension
Stabilizer Bar Link
Removal and Installation
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct retention of these parts.
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury Procedures.
Remove the wheel and tire. For additional information, refer to Wheels and Tires Removal and Replacement.
2. NOTICE: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose may occur.
Remove the bolts and position the caliper, pads and anchor plate assembly aside.
- Support the caliper and anchor plate assembly using mechanic's wire.
- To install, tighten to 160 Nm (118 lb-ft).
3. Remove the brake disc.
4. NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove the stabilizer link upper nut.
- Discard the nut.
- To install, tighten the new nut to 63 Nm (46 lb-ft).
5. NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove the stabilizer link lower nut and the stabilizer bar link.
- Discard the nut.
- To install, tighten the new nut to 55 Nm (41 lb-ft).
6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury Description and Operation.
To install, reverse the removal procedure.
7. If equipped with a fire suppression system, repower the system.