Pinpoint Test V: The Cruise Control Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test V: The Cruise Control Indicator Is Never/Always On

Normal Operation

The Instrument Cluster (IC) receives the cruise control data from the PCM over the High Speed Controller Area Network (HS-CAN). When the cruise control is engaged, the PCM provides a signal to the IC to illuminate the cruise control indicator.

This pinpoint test is intended to diagnose the following:

- Cruise control system
- PCM
- IC

PINPOINT TEST V: THE CRUISE CONTROL INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
V1 CHECK THE CRUISE CONTROL OPERATION


- Verify the cruise control operates.
- Does the cruise control operate correctly?

Yes
GO to V2.

No
REFER to Cruise Control Testing and Inspection.

-------------------------------------------------
V2 CARRY OUT THE IC INDICATOR LAMP ACTIVE COMMAND USING THE SCAN TOOL


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger .
- Select the IC cruise control indicator (SC_SET) active command on and off. Observe the cruise control indicator.
- Does the cruise control indicator illuminate when selected on and turn off when selected off?

Yes
INSTALL a new PCM. REFER to Electronic Engine Controls Service and Repair. TEST the system for normal operation.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------