Instrument Cluster Finish Panel

Instrument Cluster Finish Panel









Removal and Installation

1. Place the selector lever in the No. 1 position.

2. NOTE: The ignition switch must be in the OFF position if disconnecting the Passenger Air Bag Deactivation (PAD) indicator electrical connector. Otherwise, a DTC will be set in the Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.

Position the ignition switch in the OFF position and wait at least one minute.

3. Remove the audio unit. For additional information, refer to Information and Entertainment Systems Service and Repair.

4. Remove the RH instrument panel finish panel and disconnect the 3 electrical connectors.

5. Remove the LH instrument panel finish panel and disconnect the electrical connector.

6. Tilt the steering column in the full down position.

7. Remove the 8 screws and the instrument cluster finish panel.
- Disconnect the electrical connectors.

8. To install, reverse the removal procedure.