Parking Brake Cable - Front

Parking Brake Cable - Front









Removal and Installation

1. Using the parking brake release handle, release the parking brake control.

2. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury Procedures.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

3. Pull the parking brake adjuster clip downward.





4. Apply the parking brake control fully.

5. Push upward on the parking brake adjuster clip to lock the adjuster.





6. Using the parking brake release handle, release the parking brake control.

7. Disconnect the front parking brake cable from the LH rear parking brake cable at the cable union.





8. Press the retaining tabs and remove the front parking brake conduit from the frame bracket.





9. Press the retaining tabs and disconnect the front parking brake cable conduit from the parking brake control bracket.

10. Remove the front parking brake cable bracket bolt.
- To install, tighten to 12 Nm (106 lb-in).

11. Disconnect the front parking brake cable from the parking brake control.

12. Push the front parking brake conduit grommet through the body and remove the front parking brake cable.

13. To install, reverse the removal procedure.
- Adjust the parking brake cable tension. For additional information, refer to Parking Brake Cable Adjustment Adjustments.

14. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury Description and Operation.

If equipped with a fire suppression system, repower the system.