Fender Splash Shield - LH

Fender Splash Shield - LH









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury Procedures.

Disconnect the battery. For additional information, refer to Battery, Mounting and Cables Battery Disconnect.

3. Remove the air cleaner. For additional information, refer to Intake Air Distribution and Filtering Air Cleaner.

4. Remove the bolt and position the PCM aside.
- To install, tighten to 10 Nm (89 lb-in).

5. Release the wiring harness locator from the fender splash shield.

6. Release the front ABS sensor wiring harness locator.

7. Remove the air cleaner housing insulator.

8. Remove the upper fender splash shield bolt.
- To install, tighten to 12 Nm (106 lb-in).

9. If equipped, remove the air compressor bracket nuts.
- To install, tighten to 8 Nm (71 lb-in).

10. If equipped, disconnect the air compressor electrical connector.

11. If equipped, release the air pressure hose locator.

12. If equipped, disconnect the pin-type retainer and position the air compressor air intake aside.

13. Remove the 2 inner bolts, the pin-type retainer and the fender splash shield.
- To install, tighten to 12 Nm (106 lb-in).

14. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury Description and Operation.

To install, reverse the removal procedure.