Brake Disc

Brake Disc

Removal and Installation

1. Remove the wheel and tire.

2. NOTICE: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.

Remove the brake caliper anchor plate bolts and discard. Position the brake caliper anchor plate aside.

- To install, tighten the new anchor plate bolts to 110 Nm (81 lb-ft).

3. Remove and discard the brake disc screw.
- To install, tighten the new brake disc screw to 21 Nm (15 lb-ft).

4. Remove the brake disc.

5. To install, reverse the removal procedure, using 2 new brake caliper anchor plate bolts.
- Apply brakes several times to verify correct brake operation.