Antenna Cable - Satellite Radio

Antenna Cable - Satellite Radio

Wagon

NOTE: Headliner shown removed for clarity.











Sedan

NOTE: Headliner and rear seat shown removed for clarity.










Removal and Installation

Wagon

1. Remove the RH quarter trim panel.

Sedan

2. Remove the LH luggage compartment trim panel.

3. Remove both C-pillar trim panels.

All vehicles

4. Remove both D-pillar trim panels.

5. Disconnect the satellite radio antenna cable-to-Satellite Digital Audio Receiver System (SDARS) module electrical connector.

6. Carefully lower the rear of the headliner to gain access to the satellite antenna.

7. Loosen the satellite radio antenna cable bolt and remove the satellite radio antenna cable.
- To install, tighten to 7 Nm (62 lb-in).

8. To install, reverse the removal procedure.