Removal and Replacement

Engine Mount













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.

2. Release the fuel system pressure.

3. Remove the engine coolant degas bottle.

4. Remove the lower intake manifold. For additional information, refer to Lower Intake Manifold Lower Intake Manifold.

5. Remove the bolt and position aside the ground wire.
- To install, tighten to 10 Nm (89 lb-in).

6. Remove the bolt and damper.
- To install, tighten to 23 Nm (17 lb-ft).

7. Remove the engine mount bracket bolt.
- To install, tighten to 115 Nm (85 lb-ft).

8. Install the Universal Adapter Brackets and the Engine Lifting Brackets.

1. Position the 2 Universal Adapter Brackets on top of the cylinder block.

2. Install 2 M8 x 1.25 x 36 mm (1.41 in) bolts and tighten to 10 Nm (89 lb-in).

3. Position the Engine Lifting Bracket onto the 2 Universal Adapter Brackets.

4. Fasten the Engine Lifting Bracket to the 2 Universal Adapter Brackets with a suitable nut and bolt.





9. Install the Engine Support Bar and raise the engine 25 mm (0.98 in).





10. Remove the 3 engine mount bracket nuts.
- To install, tighten to 63 Nm (46 lb-ft).

11. Remove the nut, 2 bolts and the engine mount.
- To install, tighten to 55 Nm (41 lb-ft).

12. NOTE: If the engine mount bracket is to be removed, the engine must be lowered to avoid contact between the A/C tubes and the engine mount bracket.

Use the Engine Support Bar to lower the engine 25 mm (0.98 in).

- Remove the engine mount bracket.

13. To install, reverse the removal procedure.