Roof Opening Panel Glass

Roof Opening Panel Glass

1. Open the roof opening panel to the VENT position.

2. Remove the 4 roof opening panel glass screws.
- To access the glass screws, unclip the top portion of the concertina blind and position aside as shown.

- To install, tighten to 6 Nm (53 lb-in).





3. To install, reverse the removal procedure.
- Verify that the roof opening panel glass is centered and aligned before tightening the roof opening panel glass screws. For additional information, refer to Roof Opening Panel Alignment Roof Opening Panel Alignment.

- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.