Radio/Stereo: Service and Repair

Satellite Digital Audio Receiver System (SDARS) Module









Removal and Installation

1. NOTE: Module configuration is only required if a new Satellite Digital Audio Receiver System (SDARS) module is being installed.

Upload the SDARS module configuration information to the scan tool.

2. Remove the rear seat backrest.

3. Disconnect the satellite radio antenna cable and the SDARS module electrical connectors.

4. Remove the 3 nuts and the SDARS module.
- To install, tighten to 5 Nm (44 lb-in).

5. To install, reverse the removal procedure.
- Download the configuration information to the SDARS module.