Steering Linkage Test

Steering System






Component Tests

Steering Linkage Test

1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury. Procedures

If equipped with a fire suppression system, depower the system.

2. NOTE: Excessive vertical motion of the studs relative to the sockets may indicate excessive wear.

With the vehicle on the ground and the parking brake applied, start the vehicle and carry out the following:

- Have an assistant rotate the steering wheel back and forth 360 degrees and watch for relative motion of the studs in the steering linkage ball sockets.

- Watch for loose steering gear mounting.

3. As an additional check, with the Key ON Engine OFF (KOEO) and the front wheels raised off the ground, grasp the wheel at the front and rear and watch for excessive play or binding in the joints while trying to steer the wheels.

4. Install new components if necessary. Tighten any worn, damaged or loose components.

5. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury. Procedures

If equipped with a fire suppression system, repower the system.