Lumbar Assembly

Lumbar Assembly

Removal

NOTE: Driver side shown, passenger similar.

Police vehicles

1. Pull the zippers out from underneath the material, unzip both zippers and position the backrest trim cover up to access the backrest trim panel.

2. Remove the backrest trim panel.

1. Remove the 2 screws located at the bottom of the backrest trim panel.

2. Pull out at the bottom and slide the backrest trim panel up to disengage the 2 upper retaining hooks.

Non-police vehicles

3. Release the backrest trim cover J-clips.
- Release the lower J-clip first and then release the 2 side J-clips.

All vehicles

4. Release the rear outboard cushion J-clips.

5. Release the cushion trim cover rear corner J-clip.

6. NOTE: The lumbar motor, bladder, hose and backing board are serviced as an assembly.

Detach the lumbar motor bracket clip.

7. Disconnect the electrical connector.

8. Detach the 2 lumbar support bracket clips (1 shown) and slide the lumbar assembly up to remove.

Installation

All vehicles

1. Slide the lumbar support bracket and lumbar assembly on the lumbar seat frame until seated on the 2 clips.

2. Connect the electrical connector.

3. Install the lumbar motor and attach the lumbar motor bracket clip.

4. Attach the cushion trim cover rear corner J-clip.

5. Attach the cushion trim cover rear J-clip.

Non-police vehicles

6. NOTE: Note the alignment of the 2 side J-clips at the top of the seat to avoid bunching.

Attach the backrest trim cover J-clips.

- Attach the 2 side J-clips first and then attach the lower J-clip.

Police vehicles

7. NOTICE: Inspect the seat backrest trim panel retaining hooks for damage. If damaged, install a new seat backrest trim panel.
Install the backrest trim panel.

1. Angle the top of the seat backrest trim panel inward and down to engage the 2 upper retaining hooks to the backrest frame.

2. Push in on the lower backrest trim panel and install the 2 screws.

8. Pull the seat backrest material down, zip both zippers and tuck the zippers under the material.