Test J: The Heated Seat Is Inoperative - Driver, Does Not Operate In High

PINPOINT TEST J: THE HEATED SEAT IS INOPERATIVE - DRIVER, DOES NOT OPERATE IN HIGH

Normal Operation
The heated seat is activated when the heated seat switch sends a ground signal to the heated seat module input from circuit 1020 (DG/VT) to activate HI heat or OFF. The system will remain ON until the module times-out or is switched OFF.

This pinpoint test is intended to diagnose the following:
- Faulty circuit
- Faulty heated seat switch
- Faulty heated seat module

J1-J2:

J2-J3: